Connecting a PC Directly to a WorkSeries Ethernet Controller (Static IP Address) (WorkSeries 400)

• Related Articles

• Connecting a PC Directly to a WorkSeries Ethernet Controller (Static IP Address) (WorkSeries 200 & 300)

  This training instruction will walk you through the necessary steps to assign a static IP address to your machine as well as connect to the machine directly, without have to connect the machine to a Local Area Network. 

• Touchscreen Firmware Update - September 2020 (WorkSeries 400)

  Check Current Firmware Version This update is for touchscreen firmware Version 1.23.2+3. Please only upgrade if your current version is less than this version. To check the current version of firmware on your touchscreen follow the instructions ...

• Machine Firmware update - September 2020 (WorkSeries 400)

  Check Current Firmware Version This update is for Duet Firmware version 3.1.1. Please only upgrade if your current version is less than 3.1.1. To check the current version of firmware on your machine follow the applicable instructions below: Via ...

• Machine Firmware update - September 2020 (WorkSeries 200 & 300)

  Check Current Firmware Version This update is for Duet Firmware version 3.1.1. Please only upgrade if your current version is less than 3.1.1. To check the current version of firmware on your machine follow the applicable instructions below: Via ...

• Touchscreen Firmware Update - September 2020 (WorkSeries 200 & 300)

  Check Current Firmware Version This update is for touchscreen firmware Version 1.23.2+3. Please only upgrade if your current version is less than this version. To check the current version of firmware on your touchscreen follow the instructions ...