Volcano Extruder Validation Prints

Volcano Extruder Validation Prints

The 3DP Validation Prints are standard print files that are provided on the internal SD card for each WorkSeries machine. The g-codes have been verified in our factory and each of these is printed on, and ships with, your new WorkSeries 200, 300 or 400 machine so that you can compare your print to the factory provided print. We recommend using these prints as a baseline for validating and troubleshooting machine operation.


Downloads

Work Series 200 Volcano Extruder Validation Prints: https://drive.google.com/open?id=1MYooEts4ObPUd386PTfONM_6V6RA8KmP

Work Series 300 Volcano Extruder Validation Prints: https://drive.google.com/open?id=1w7CrFKZAv4uE1lEs1-5i2GxV2961QRgi

Work Series 400 Volcano Extruder Validation Prints: https://drive.google.com/open?id=1yaa4xPbUMhCBz_7zeem99IQ273uWuQD7
    • Related Articles

    • HFE 300 Extruder Validation Prints

      The 3DP Validation Prints are standard print files that are provided on the internal SD card for each WorkSeries machine. The g-codes have been verified in our factory and each of these is printed on, and ships with, your new WorkSeries 200, 300 or ...
    • HFA Verification Prints

      The 3DP Validation Prints are standard print files that are provided on the internal SD card for each WorkSeries machine. The g-codes have been verified in our factory and each of these is printed on, and ships with, your new WorkSeries 200, 300 or ...
    • Replacing the Hotend (Volcano)

      These instructions are for removing and replacing a hotend on a Gen 2 Bulldog extruder. You may want to replace the hotend to upgrade your extrude, or to replace a damaged or worn out component. Tools needed: • 2mm hex wrench • 2.5mm hex wrench • 3mm ...
    • Replacing the Volcano Hotend (3DP 1000)

      These instructions are for removing and replacing a hotend on a Gen 2 Bulldog extruder.  You may want to replace the hotend to upgrade your extrude, or to replace a damaged or worn out component. Tools needed: • 2mm hex wrench • 2.5mm hex wrench • ...
    • Replacing the Volcano Hotend (Classic WorkBench)

      These instructions are for removing and replacing a hotend on a Gen 2 Bulldog extruder.  You may want to replace the hotend to upgrade your extrude, or to replace a damaged or worn out component. Tools needed: • 2mm hex wrench • 2.5mm hex wrench • ...