WorkSeries Dual Calibration (WorkSeries 200 & 300)

WorkSeries Dual Calibration (WorkSeries 200 & 300)

These instructions are specifically for calibrating the toolhead offsets on your Work Series machine. If you are looking for the entire calibration process please visit the following page: WorkSeries Calibration Video 

If you have any issues or questions, feel free to get in touch with us by submitting a ticket here: https://support.3dplatform.com/portal/newticket


    • Related Articles

    • WorkSeries Dual Calibration (WorkSeries 400)

      These instructions are specifically for calibrating the toolhead offsets on your Work Series machine. If you are looking for the entire calibration process please visit the following page: WorkSeries Calibration Video  If you have any issues or ...
    • Machine Firmware update - September 2020 (WorkSeries 400)

      Check Current Firmware Version This update is for Duet Firmware version 3.1.1. Please only upgrade if your current version is less than 3.1.1. To check the current version of firmware on your machine follow the applicable instructions below: Via ...
    • Machine Firmware update - September 2020 (WorkSeries 200 & 300)

      Check Current Firmware Version This update is for Duet Firmware version 3.1.1. Please only upgrade if your current version is less than 3.1.1. To check the current version of firmware on your machine follow the applicable instructions below: Via ...
    • Machine Calibration Video (WorkSeries 400)

      This video explains the basics of calibrating the 3D Platform WorkSeries printers. *Note: The dual extrusion calculator mentioned in the video can be downloaded below* If you have further questions, please submit a support ticket.
    • Machine Calibration Video (WorkSeries 200 & 300)

      This video explains the basics of calibrating the 3D Platform WorkSeries printers. *Note: The dual extrusion calculator mentioned in the video can be downloaded below* If you have further questions, please submit a support ticket.