General
WorkSeries Print cooling fan won't power on.
In most cases if the print cooling fan doesn't power on, either the fan itself is broken or there is a wiring issue (fan unplug, fan connectors damaged, etc,) Additionally if the fan is not enabled in the slicer, it may not turn on during a print ...
Periodic maintenance guidelines
Ensure machine is powered down and in a safe state before performing maintenance Dispose of oily rags or towels properly to avoid risk of fire Cleaning & lubricating the gantry General info The actuators need to be cleaned regularly to prevent dust ...
Filament sensor troubleshooting
Please follow these steps if the filament sentinel sensors are not working as expected. General sensor function check With the machine on, please use the green LEDs on the filament sensor body to check the function. They work in the following ...
Motor coupling change process
Part numbers: Part number Description Used for RW-EKL5/HUB/5 Coupling half 5mm bore All actuator shafts EXCEPT WS400 Y actuators RW-EKL5/HUB/6 Coupling half 6mm bore WS400 Y actuator shafts RW-EKL5/HUB/6.35 Coupling half 6.35mm (1/4in) bore 3DP1000 ...
Molex crimp part numbers for 3DP1000, WorkBench, and WorkSeries
Molex Microfit 3.0 series. Crimp pins: Female pin: 43030-0001 Male pin: 43031-0001 Connector housings: 2-pin receptacle: 43645-0200 2-pin plug: 43640-0201 4-pin receptacle: 43645-0400 4-pin plug: 43640-0401 Crimping tool: 63819-0000
Step-Servo drive troubleshooting.
Problem with a motor not moving properly? Check these items: Basic checks Ensure machine is powered on properly Ensure e-stops are not depressed. Twist e-stops to disengage. Mechanical Check motor couplings, tighten screws if necessary using 2.5mm ...
SurePrint Servo Upgrade Instructions (Classic WorkBench)