The table below contains the STL files for each of the printed components on the 200 and 300 series machines. Original machine parts are printed out of black PETG material. ABS and PC would also be suitable materials for these components. If you have ...
Check Current Firmware Version This update is for touchscreen firmware Version 1.23.2+3. Please only upgrade if your current version is less than this version. To check the current version of firmware on your touchscreen follow the instructions ...
Check Current Firmware Version This update is for Duet Firmware version 3.1.1. Please only upgrade if your current version is less than 3.1.1. To check the current version of firmware on your machine follow the applicable instructions below: Via ...
This training instruction will walk you through the necessary steps to assign a static IP address to your machine as well as connect to the machine directly, without have to connect the machine to a Local Area Network.
Print speed can be a difficult setting to determine for your prints. It is based on layer height and nozzle, therefore it can change somewhat frequently. To assist with this, we have developed a print speed calculator to assist in determining what ...
These instructions are specifically for calibrating the toolhead offsets on your Work Series machine. If you are looking for the entire calibration process please visit the following page: WorkSeries Calibration Video If you have any issues or ...
This video explains the basics of calibrating the 3D Platform WorkSeries printers. *Note: The dual extrusion calculator mentioned in the video can be downloaded below* If you have further questions, please submit a support ticket.
These instructions are for removing and replacing a hotend on a Gen 2 Bulldog extruder. You may want to replace the hotend to upgrade your extrude, or to replace a damaged or worn out component. Tools needed: • 2mm hex wrench • 2.5mm hex wrench • ...
Problem: In certain situations the WorkSeries controller will not resume after pausing a print. The printer will hang and not respond to input, this problem is intermittent The issue was identified on testing: WorkSeries controller resume script ...